A small scale (45x25mm) prototyping board for the LoRa RN2483 to develop internet of things applications. Named the SODAQ ONE (EU), it includes a LoRa and GPS Antenna.

  • LoRa and GPS Connectivity
  • Small Form Factor (45 x 25 mm)
  • Arduino Compatible
  • Free Tracking Software (Universal Tracker)
  • Extremely low power, solar rechargable

Purchase a SODAQ ONE in our webshop

€64,95 (€78,59 Incl. tax)

Jump into the world of LoRa!

This is the third generation of our successful SODAQ ONE development board. It is equipped with a solar charge controller and runs on a LiPo or a permanent battery. It has the Ublox Eva M8M GPS module (depending on which version is chosen). This module is not only miniature, but with it's assisted GPS feature it can get a fix within seconds. We've now added an extremely low power Accelerometer/Magnetometer. This gives the board a nifty feature where it can stay in (deep) sleep mode until it moves. An essential feature for developing low power devices.

Let's imagine you want to develop a bicycle tracker using the SODAQ ONE. You would like to track the position of the bike, but only when it has moved. This is possible if you keep the device in deep sleep until it detects motion. If the motion continues for a while, the bicycle may have changed position so only then the GPS will switch on to get a new reading and send this location over the LoRa network. Efficient right? This system will allow you make most efficient use of your battery capacity by only using the GPS when really needed, essentially increasing the battery life of your system. The board is so small (45x25 mm) you can fit it inside almost anything (Seriously, look at the picture). Whether you want to build a weather station, control street lights or get a signal when you have received (snail) mail. It's all possible with the SODAQ ONE. New in this version is that we have added JST headers (receptacles) so you can now directly plug in a LiPo battery and Solar Panel if you like.


MicrocontrollerATSAMD21G18, 32-Bit ARM Cortex M0+
CompatibilityArduino M0 Compatible
Size40 x 25 mm (V1 and V2), 45 x 25 mm (V3)
Operating Voltage3.3V
I/O Pins14, All can be used for digital and analog with PWM, UART, SPI and TWI (I2C)
Analog Output Pin10-bit DAC
External InterruptsAvailable on all pins
DC Current per I/O pin7 mA
Flash Memory256 KB
EEPROMUp to 16KB by emulation
Clock Speed48 MHz
Power5V USB power and/or 3.7 LiPo battery
ChargingSolar charge controller, up to 500mA charge current
LoRaMicrochip RN2483 or RN2903 Module
GPSuBlox EVA M8M (ONE V2 and V3)
Accelerometer/MagnetoLIS3DE(ONE V2) / LSM303AGR (ONE V3)
USBMicroUSB Port

What options do you have for visualization?

This board is fully programmable implying that the below demo is not an accurate representation of the boards full potential. We have loaded our universal tracker software onto Cayenne following the tutorial on our support page, and within minutes we created a fully operational tracking device.


Contact Us

Stijn Van Stekelenburg
Product Manager
+31 6 22 69 36 99

Let Us Contact You



Message (optional)

Your message has been sent successfully!
Error, please retry. Your message has not been sent.